Static Load Transfer

THE CHALLENGE AND TRUTH OF STATIC LOAD TRANSFER

Your load transfer calculation? request here

Everything needs to be as efficient as possible

Logistics have developed and changed drastically over the last decade. Loads became higher, racks taller and forklifts faster. The question is however, have the construction materials adapted to these higher demands? What about construction joints for industrial floors? Do they fulfil the requirements of load transfer and limitation of deformation?

Racks and forklift

What is static load transfer?

Load in the middle

actie 100% reactie 100% 50% 50%

Load at the joint

actie 100% reactie 100% ± 40% ± 60%

Load at the perimeter

actie 100% reactie 100% 100%

Generally, the most critical static loads for an industrial floor comes from racks (back to back racking). This problem remains the same for joints and often becomes the decisive case for the final result of your industrial floor. A high performing construction joint is way more than a fancy looking wave form. For static loads, everything that matters is transferring loads while limiting deformations!

What is dynamic load transfer? click here

Why is good load transfer so important

Low joint performance

actie 100% reactie 100% 30% 70%

High joint performance

actie 100% reactie 100% 45% 55%

The construction joint is integral part of your industrial floor. Only if these joints work efficiently, your hole floor can be efficient.

Different products have different performances

Guess what? As for other construction materials too, different joints have different properties. This starts with the obvious visible things, but the most important property is LOAD TRANSFER!

Does this matter to me?

0% 25% 75% 100% 50%

What do you guess the percentage of correctly designed industrial floors is?

We estimate 70% of industrial floors are UNDER-DESIGNED and load transfer is not properly addressed . Only a small part of industrial floor designs take the performance of a joint seriously or into consideration at all. Most of these designs just assume a fixed rate of load transfer at a construction joint.

What works for you?

The only way to know what works for you is to calculate.

Online calculation tool

Request access now and use the free online tool. It helps to compare and understand different load transfer systems and allows for a pre-check of your project.

load transfer performance calculator

Online form to fill

Just provide us with all the necessary data and our technical support team will take care of your request free of charge!

Need a complete design check?

We are happy to provide you with a full design check. Please contact:

Dirk Van Cauteren

Tel. +32 89 39 00 73

dirkvc@hcjoints.be